Table of Contents
Advertisement
2
New validation codes
3
Smooth stop in probing move (G75/G76)
PROBEDEF (P168)
4
Square-corner or round-corner machining when changing
tool offset
TOOLTYPE (P167)
Due to new software options, the validation code changes from 16
to 24 characters. The new codes are also valid for the Memory
Cards with software versions older than V7.11
From this version on, a smooth stop may be defined for probing
moves. When the probe pulse is detected, the following error is not
reset, thus making the probe stop more smoothly.
It defines the type of stop for the probing moves. It has 16 bits. Bit 16
selects the selected type of stop.
PROBEDEF xxxx xxxx xxxx xxx 0/1
0 Standard Stop.
1 Smooth stop.
When setting the smooth stop, a.m.p "DERGAIN (P25)" and s.m.p.
"FFGAIN (P25)" should be set to zero. This may be done by setting
the range of gains through g.m.p. "ACTGAIN2 (P108)" with the bit
corresponding to G75/G76.
When executing a tool change, the change takes place at the end of
the path. Using g.m.p. "TOOLTYPE (P167)" it is possible to define
how to machine the corner where the tool offset is being changed.
This corner may be machined in square corner (sharp) or rounded.
This parameter is only taken into consideration when working in
round corner. When working in square corner, the corner is always
machined in square corner mode.
It has 16 bits. Bit 2 selects the type of corner.
TOOLTYPE x 0/1 xx xxxx xxxx xxxx
0 Square corner.
1 Round corner.
By default 0
By default 0
N
F
EW
EATURES
(S
M: 7.1
OFT
New validation
codes
Page 45 of 48
)
X
Advertisement
Table of Contents
