Table of Contents
Advertisement
Chapter 4
Electrical Safety Guidelines
To avoid electrical shock, check the power cords as follows:
Checking the Power Cords
•
Use the exact type of power cords as required.
•
Be sure to use power cord(s) that came with safety certifications.
•
The power cord(s) must be compliant with the AC voltage requirements in your
region.
•
The power cord plug cap must have an electrical current rating that is at least
125% of the electrical current rating of this product.
•
The power cord plug cap that plugs into the AC receptacle on the power supply
must be an IEC 320, sheet C13, type female connector.
•
Be sure to disconnect the power supply before accessing the StorTrends 3100
chassis or its components.
•
Plug the Power cord(s) into a socket that is properly grounded before turning on
the power.
General Electrical Safety Guidelines
Follow the guidelines below to avoid possible damages to the system or injury to
yourself:
•
Be aware of the locations of the power switches on the chassis and in the room, so
you can disconnect the power supply if an accident occurs.
•
Take extra precautionary measures when working with high voltage components.
It is not recommended to work alone.
•
Before removing or installing main system components, be sure to disconnect the
power first. Turn off the system before you disconnect the power supply.
•
Use only one hand when working with powered-on electrical equipment to avoid
possible electrical shock.
•
Use rubber mats specifically designed as electrical insulators when working with
computer systems.
•
The power supply or power cord must include a grounding plug and must be
plugged into grounded outlets.
•
Motherboard Battery: CAUTION -Make sure not to install the onboard battery
upside down to avoid possible explosion. Make sure that the positive side should
be facing up on the motherboard. This battery must be replaced only with the
same or an equivalent type recommended by the manufacturer.
•
Dispose of used batteries according to the manufacturer's instructions.
•
CD-ROM Laser: CAUTION - Do not open the enclosures of power supplies or
CD-ROM to avoid injury.
Safety Information and
Technical Specifications
WARNING
WARNING
Chapter Four : Safety Information and Technical Specifications
23
Advertisement
Table of Contents
