Spectrum Industries 55568 Assembly Instructions

Assembly Instructions
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts or
accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
1
Tip lectern onto its side
1. Using two people, carefully tip the empty lectern on its side onto a
non-abrasive surface. This will provide easier access to the back
of the audience-side panel.
(1) 0178787
Logo panel
(6) 026059
1/4" Flat washer
(6) 0104260
10-32 Keps nut
Logo Panel for Edge Lectern
55568
Tools required
"
1/4
Masking Drill with sharp
tape
1/4" drill bit
Assembly tip: Do not tighten component fasteners completely
until all have been installed. Keeping them loose will help with
alignment between parts during assembly.
"
3/8
0193960 Page 1 of 2