Table of Contents
Advertisement
SECTION 1
•
For additional safety, we strongly recommend the inclusion of safety beams.
Although the SDO4 SMART incorporates a pressure sensitive safety obstruction force
system, the addition of safety beams will greatly enhance the operating safety of an
automatic garage door and provide additional peace of mind. In some countries,
it is a mandate of law to fit safety beams. It is the sole responsibility of the owner /
installer to fit safety beams in those countries that so require
•
Always ensure that the garage door is fully-open and stationary before driving in or
out of the garage
•
Always ensure the garage door is fully-closed and stationary before moving out of its
view
•
Adjustments to the safety stop / reverse force settings must only be carried out by
a technically qualified person. Attempting to adjust the settings without suitable
technical qualification may result in severe personal injury, death and / or property
damage
•
Keep hands and loose clothing clear of the SDO4 SMART and garage door at all
times
•
In order for the safety obstruction force system to function, it must first encounter
an obstruction in the form of an object / person onto which some force MUST
be exerted. As a result, the object / person / garage door may suffer DAMAGE
AND / OR INJURY
•
The safety obstruction system is designed to work on STATIONARY objects only.
Serious personal injury, death and / or property damage may occur if the garage door
comes into contact with a moving object during an open or close cycle
•
Keep remote controls away from children
•
Take care when operating the manual release since an open door may fall rapidly due
to weak or broken springs or being out of balance
•
Each month check that the drive reverses when the door contacts a 40 mm high
object placed on the floor. Adjust if necessary and recheck since an incorrect
adjustment may present a hazard
•
Permanently fix the labels warning against entrapment in a prominent place or near
any fixed controls
•
Permanently fix the label concerning the manual release adjacent to its actuating
member
•
After installation, ensure that the mechanism is properly adjusted and that the drive
reverses when the door contacts a 40mm high object placed on the floor
•
The drive must not be used with a door incorporating a wicket door (unless the drive
cannot be operated with the wicket door open)
•
After installation, ensure that parts of the door do not extend over public foot paths
or roads
IMPORTANT SAFETY INFORMATION
page 8
www.centsys.com
Advertisement
Table of Contents
Need help?
Do you have a question about the SDO4 SMART and is the answer not in the manual?
Questions and answers