Daewoo DAT1200EM User Manual page 18

EN
WARNING
Use only identical replacement parts when servicing this product. Use of
any other parts may create a hazard or cause product damage.
ADVANCING THE CUTTING LINE AUTOMATICALLY
(See fig. A)
Follow these steps to advance the cutting line automatically.
1. Press the trigger.
2. Tap the retaining cap lightly on the ground while the motor is running.
Do not hold the retaining cap on the ground.
Note: The line cutting blade on the debris shield (safety guard) will cut
the line to the proper length.
Note: To help prevent line tangle, tap only once to lengthen the line. If
additional line is required, wait a few seconds before retapping the re-
taining cap.
Keep the line length at or near full cutting diameter.
ADVANCING THE CUTTING LINE MANUALLY
(See fig. B)
If the cutting line wears to less than the recommended length, you may
not be able to lengthen it by tapping the retaining cap.
Follow these steps to advance the cutting line manually.
1. Release the trigger and allow the trimmer to coast to a stop.
2. Unplug the trimmer.
3. Pull sharply on the line while pushing down on the retaining cap.
18