Daewoo DAT1200EM User Manual page 11

• Kickback is the result of power tool misuse and/or incorrect operating
procedures or conditions and can be avoided by taking proper pre-
cautions as given below.
a) Never place your hand near the rotating accessory. Accessory
may kickback over your hand.
b) Do not position your body in the area where power tool will move
if kickback occurs. Kickback will propel the tool in direction opposite to
the wheel's movement at the point of snagging.
c) Use special care when working corners, sharp edges etc. Avoid
bouncing and snagging the accessory. Corners, sharp edges or
bouncing have a tendency to snag the rotating accessory and cause
loss of control or kickback.
DESCRIPTION
SAFETY MANUAL included with unit. Read before operating and keep
for future reference to learn proper, safe operating techniques.
1. Guard shield
3. Cut-off knife
5. knob
7. Cable & plug
9. Main handle
11. Hanging hole
13. Front handle
15. Connector
2. Cutting head (spool)
4. Lower shaft
6. On/off switch
8. Motor housing
10. Lock-off button
12. Upper shaft
14. Retaining cap
16. Cutting nylon line
11