Crusader 5.0L MPI Instruction Manual page 50

ENGINE MAINTENANCE - 11
Cooling System Fill Procedure
NOTE: This procedure MUST be completed on a cold
engine and the engine not running.
Port Engine (No Water Heater Connections)
1. There are three venting points on the system. Open
the valve on the Heat Exchanger. Ensure that the
bleed hose is routed straight down to a low point into
an approved container.
2. Remove the pipe plug from bottom of ball valve near
the thermostat housing on the Heat Exchanger.
3. Open the Ball Valve.
4. Remove the vent plug on the top of each exhaust
manifold.
48
FILLING FRESH-WATER COOLING SYSTEM
(6.0L CES Full-Fresh Applications)
L510001-13