Crusader Sync/Cruise - Possible Operator Concerns - Crusader 5.0L MPI Instruction Manual

OPERATING INSTRUCTIONS - 5

CRUSADER SYNC/CRUISE - POSSIBLE OPERATOR CONCERNS

Concern
Sync Lamp Flashing While
Boat is Under Way
Cruise Lamp Flashing when
Syn/Cru Mode switch is
turned ON.
Cruise Lamp Flashing while
under way, Cruise Mode is
enabled.
The Slave engine is running
slower than the Master engine
and the Sync Lamp is fl ashing.
After re-starting the engines,
the Slave engine does not speed
up and follow the Master as the
Master throttle is increased.
The Slave engine will not re-start
with the Syn/Cru switch OFF.
34
Cruise
Sync
(D)
ON Set
(A) (B)
Syn/Cru Speed
OFF Cancel
Figure 5-6 Sync/Cruise Control Panel (Typical)
Possible Cause
Slave throttle handle position is
below the Master throttle handle
position.
A previous cruise set speed
remains in system memory.
Engines are operating below the
cruise Set speed.
The Slave throttle position is below
the Master throttle position.
The Slave throttle position was not
returned to the Idle/Start position
before re-starting the engines.
The Slave throttle was not returned
to the Idle/Start position before
attempting to re-start the engine.
L510001-13
(E)
(+)/Res
(C)
Speed
(-)
Corrective Action
Place Slave throttle handle to the
WOT position.
Press Cancel on the
Speed Set/Cancel switch (B). OR -
Use the Resume function (Switch C),
then place the Master throttle in the
WOT position to Resume previous
Cruise mode function and Set speed.
Place the Master throttle to the WOT
position.
Place the Slave throttle to the WOT
position.
Return the Slave throttle to the
Idle/Start position then place the
Slave throttle in the WOT position.
Place the Slave throttle in the Idle/Start
position and start the engine.