Front Panel Features; Ir Learning Sensor; Reset Features; Mounting The Ipl 250 - Extron electronics IP Link IPL 250 Reference Manual

Front Panel Features

N The IPL 250 must be set up in order to function. See chapter 3, "Software-
Front panel LED indications are described below.
RS-232 (COM):
TX = Transmitting Data
RX = Receiving Data
IPL 250
R
Power LED:
Lit When
Receiving
Power

IR learning sensor

In most cases, Extron has already produced a driver file for controlling the
projector, display, or source device you plan to use. If a device driver file is not
available, you can create your own using Extron IR Learner software, the projector
or display's remote control, and the IPL's IR learning receiver sensor, shown above.
This receiver accepts infrared signals of from 30 kHz to 1 MHz. The IR remote
control must be pointed directly at the receiver for best results. The front panel
diagram (above) indicates the best distances and angles at which to hold the remote
control.

Reset features

Reset button and LED — Pressing this recessed button causes various IP functions
and Ethernet connection settings to be reset to the factory defaults. The green
LED flashes depending on the selected reset mode. See
page 2-10

Mounting the IPL 250

based Configuration and Control," and the Global Configurator help file for
information about Global Configurator, which you must use to set up the unit.
IR: Contact Input:
LED Lights When LED Lights When
IR Port (1-4) Input Port is Closed
Transmits Data (tied to GND)
COM IR INPUT
TX RX
1
1 3 1 3
2
3
2 4 2 4
Reset Button
(recessed):
See "Resetting
the Unit," pg. 2-10
for details.
IPL 250 • Hardware Features and Installation
Relay:
LED Lights When
Relay is Activated
(tied to GND)
®
RELAY
100
1 3
LINK
ACT
2 4
IR Receiver:
IR Learning
Angle and
Distance
2–12"
(4–30 cm)
1 2 3
4 5 6
7 8 9
0
"Resetting the Unit" on
100 Mbps
Connection
Network is
Active
Data is Being
Sent/received.
2-3