ETC Unison Aero Slimline Dual Relay Controller Installation Manual page 3

E T C I n s t a l l a t i o n G u i d e
C A U T I O N :
W ( )
HITE NEUTRAL
B (120-277 VAC)
LACK
O
RANGE
WIRELESS TO
OTHER DEVICES
N o t e :
Step 4:
N o t e :
Step 5:
Unison Aero Slimline Dual Relay Controller Page 3 of 4
The UASRR has an orange external antenna that extends off one
end of the unit. Do not cut, cap, or connect this wire.
( )
ANTENNA
U
S
R
ELAY
Follow all local code requirements for terminating wiring. Notice the
harness wires on the controller unit are pre-stripped for your
installation convenience.
The UASRR controller is provided with a wire harness that serves 120 - 277
VAC power requirements. Refer to the wiring diagram above to connect
power to the controller.
a: Connect the black wire to the line input feed wire.
b: Connect the white wire to the incoming Neutral wire and the Neutral
wire of the lighting load(s).
c: Connect the red wire for circuit A to one load of the fixture or zone.
d: Connect the red wire for circuit B to the second load of the fixture or
zone.
Cut and tie back the unused line power wires. Follow all local code
requirements for tieing back unused wires.
Replace the wiring compartment cover plate and hardware.
Unison Aero Power Series
A
NISON ERO
D
LIMLINE UAL
C
ONTROLLER
( )
UASRR
Electronic Theatre Controls, Inc.
R ( )
ED RELAY OUTPUT
L
IGHTING
L
IGHTING
R ( )
ED RELAY OUTPUT
L
OAD
L
OAD