Icom IC-2SA Instruction Manual page 2

FOREWORD
This instruction manual explains basic operation of the
IC-2SA/SE 144 MHz FM TRANSCEIVER. When you
require additional information, refer to a separate sheet
called "'Tech Talk,'' available from your nearest Icom
Dealer or Service Center. |
USE IN THE NORMAL CONDITION
If one of the function guides
described at right appears during .
operation or when first applying jan on coy gm rae
power, the transceiver may not oe
operate as explained in this instruc-
tion manual. |
One of these guides
At that time, the transceiver should be set to normal
conditions as follows:
1) Turn power OFF.
2) While pushing [LIGHT] and [V/M], turn power ON.
e Be sure the function guide indicator disappears.
FIRST APPLYING POWER
If the transceiver seems to malfunction when first applying
power, the internal rechargeable backup battery may be
exhausted. This condition may occur if the transceiver is
operated more than 1 week after the attached battery pack
is exhausted.
At this time, the transceiver should be reset as follows:
1) Connect the wall charger to the top panel. (Asia version:
install batteries into the battery case.)
2) Push and hold [MONI- [MONITOR] [VOL]
TOR] and [LIGHT]
then rotate [VOL] to
turn ON power.
[LIGHT]
3) Turn OFF power, then
wait until the battery
pack is charged. (Not
applicable to Asia
version)