Parts Included; Important Safety Instructions - Humanscale float mini Assembly Instructions Manual

Tools Required

Parts Included

①
Work Surface
④
Base
⑦
3x M6x25mm Screws
⑧
4x M6x35mm Screws

IMPORTANT SAFETY INSTRUCTIONS

• CLEAR WORKSURFACE AND PUT THE WORKSURFACE INTO ITS LOWEST POSITION BEFORE MOVING THE TABLE.
• Use two hands on side of table when raising and lowering.
• Do not raise or lower the table with open beverages on worksurface.
• Avoid any fast or hard impacts onto worksurface side to avoid unintentional tipping.
• When in use ensure no fixed blockage or obstruction are near to prevent tipping.
DO NOT:
• Put more than 12 lbs on the work surface
• Lean on the table work surface when it is the raised position
• Mount unauthorized items to the work surface or table (i.e., monitor arms, charging devices, power strips/cords, etc.).
• Move the table in a raised position.
• Move the table over angled surface, platforms, course/textured/uneven floor.
• Replace the work surface with another work surface.
• Use the table on an angled surface, platform, course/textured/uneven floor
• Place the product outside or expose it to outside elements (wind, excessive sunlight, continued exposer to moisture).
• Sit and/or stand on the work surface.
• Stand or ride the base.
• Take apart the lifter.
• Tampering with internal mechanism.
• Use of product on stairs or ramps
• Modification to casters or glides, either component or configuration.
• Applying excessive heat to any part of the product.
2
phillips head screwdriver
②
Mounting Plate
⑤
3x Glides
⑨
4x #8x38mm Screws
⑩
2x #6x16mm Screw
⑪
9x #10x19mm Screws
③
⑥
3x Casters
*Optional
⑫
2x Cable Clip
⑬
4mm Hex Key
⑭
12mm Open Wrench
(only with casters)
Column with
Actuator