Using Multi Operations; Using System Off; Controlling Components - Pioneer Elite SC-37 Operating Instructions Manual

10 Controlling the rest of your system (In case of SC-37)
8 Repeat steps 5 to 7 to program a sequence of up to
commands.
When you're finished, use / to select 'EDIT
9
EXIT' from the menu and press ENTER.
You will return to the remote control Setup menu. Select
EXIT SETUP to exit.

Using multi operations

You can start multi operations with the receiver switched
on, or in standby.
1 Press MULTI OPERATION.
MULTI OPERATE flashes in the display.
2 Press an input function button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed
1
automatically.

Using System off

1 Press MULTI OPERATION.
MULTI OPERATE flashes in the display.
Press  SOURCE.
2
The command sequence you programmed will run, then
all Pioneer components will switch off
3
receiver.
Note
1 With this remote control, the IR and RF modes can be selected separately for the individual input functions. To perform a multi operation on
a device (input function) for which the IR mode is selected, point the remote control toward the remote sensor on that device.
2 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
3 • With this remote control, the IR and RF modes can be selected separately for the individual input functions. To turn off the power of a device
(input function) for which the IR mode is selected using the System Off function, point the remote control toward the remote sensor on that device.
• When the power code of another brand is registered, the power on/off operation may be inverted. When using the System Off function for a
multi operation including the power codes of other brands, always check that the power of all the components has turned off.
88
En
MAIN
RECEIVER SOURCE
ZONE2 3
MULTI MULTI
OPERATION OPERATION
BDR
BD DVD DVR HDMI
NET RADIO
TV CD HMG ADAPTER
USB OPTION
iPod TUNER 1 2
MULTI CH
MAIN
RECEIVER SOURCE
ZONE2 3
MULTI MULTI
OPERATION OPERATION
BDR
BD DVD DVR HDMI
NET RADIO
TV CD HMG ADAPTER
USB OPTION
iPod TUNER 1 2
MULTI CH
2
, followed by this

Controlling components

This remote control can control components after
entering the proper codes (see Selecting preset codes
directly on page 84). Set the remote control operation
selector switch to SOURCE, then press the input function
buttons to select the component.
• TV CONTROL on the remote control are dedicated to
control the TV assigned to the TV operation selector
switch. If you have two TVs, assign the main TV to the
TV operation selector switch.
MAIN
RECEIVER
ZONE2
BD DVD
TV CD
USB
iPod TUNER
MULTI CH
PHONO IN
INPUT SELECT
AUX
TV
CH
TV CONTROL
INPUT
AUDIO
PARAMETER
LIST
TOP MENU
BAND
PRESET
CATEGORY
HOME
MENU
iPod CTRL
STATUS PHASE CTRL
THX MPX
AUTO/ALC/
DIRECT STEREO
PGM MENU
SIGNAL SEL SLEEP
A.ATT SBch
D.ACCESS
CLR
SOURCE
3
MULTI
OPERATION
BDR
DVR HDMI
NET RADIO
HMG ADAPTER
OPTION
1 2
VIDEO CD-R
LIGHT
SOURCE
RECEIVER
VOL
VOL
MUTE MUTE
VIDEO
PARAMETER
TUNE
TOOLS
T.EDIT
GUIDE GUIDE
PRESET
ENTER
RETURN
TUNE
PTY SEARCH
CH LEVEL
PQLS MEMORY
STANDARD ADV SURR
DIMMER AUDIO
MCACC INFO
DISP
HDMI OUT
CH
CLASS
ENTER