Remote Control Display - Pioneer Elite SC-37 Operating Instructions Manual

Audio/video multi-channel receiver

Hide thumbs Also See for Elite SC-37:

Specifications (2 pages)

Service manual (290 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

127

128

129

130

131

132

133

134

135

136

137

138

139

140

141

142

143

144

145

146

147

148

Table of Contents

Controls and displays

10 Receiver Control buttons

Set the remote control operation selector switch to

RECEIVER first to access:

STATUS – Press to check selected receiver settings

(page 81).

PHASE CTRL – Press to switch on/off Phase Control

or Full Band Phase Control (page 63).

CH LEVEL – Press repeatedly to select a channel,

then use / to adjust the level (page 116).

THX – Press to select a Home THX listening mode

(page 60).

PQLS – Press to select the PQLS setting (page 75).

AUTO/ALC/DIRECT – Switches between Auto

Surround (page 59), Auto Level Control, Optimum

Surround mode and Stream Direct mode (page 62).

STEREO – Switches between stereo playback and

Front Stage Surround Advance modes (page 61).

STANDARD – Press for Standard decoding and to

switch various modes (2 Pro Logic, Neo:6, etc.)

(page 59).

ADV SURR – Use to switch between the various

surround modes (page 61).

SIGNAL SEL – Use to select an input signal (page 62).

SLEEP – Use to put the receiver in sleep mode and

select the amount of time before sleep (page 81).

DIMMER – Dims or brightens the display (page 81).

A.ATT – Attenuates (lowers) the level of an analog

input signal to prevent distortion (page 80).

SBch – With this receiver, SBch cannot be used.

MCACC – Press to switch between MCACC presets

(page 62).

HDMI OUT – Switch the HDMI output terminal

(page 81).

LIGHT

Press to turn on/off the illumination for the buttons.

12 Remote control operation selector switch

Set to RECEIVER to operate the receiver, TV or SOURCE

to operate the TV or the source device.

When this switch is set to RECEIVER, the receiver can be

controlled (used to select the white commands). Also use

this switch to set up surround sound.

Note

1 Press and hold in the LIGHT button for 5 seconds to change the illumination mode 1 or 2. When set to LIGHT MODE 2 (default), the

illumination only lights when the remote control LIGHT button is pressed. When switched to LIGHT MODE 1, the illumination lights whenever

buttons are operated. Setting LIGHT MODE 1 will shorten the service life of the batteries.

2 The display lights when a remote control operation is performed, then turns off after 20 seconds if no other operation is performed. When in

the Remote Setup mode, the setup is canceled and the display turns off if no operation is performed for 1 minute (page 83).

3 • This is displayed when an RF adapter is connected to the receiver and paired with the remote control. For details, see Using the RF

communications function on page 91.

• Depending on the communications environment, two-way communications may not work well and the remote control display may not reflect

the receiver's status.

13 VOL +/–

Use to set the listening volume.

14 MUTE

Mutes the sound or restores the sound if it has been

muted (adjusting the volume also restores the sound).