Home Media Gallery (Sc-37 Only) - Pioneer Elite SC-37 Operating Instructions Manual

Additional information
Status messages Cause
Check Sirius Tuner The SiriusConnect™ tuner is not properly
connected.
Acquiring Signal The SIRIUS signal is too weak at the current
location.
Subscription Updating Unit is updating subscription.
Updating Channels Unit is updating the channel information.
Invalid Channel Selected channel is not available/does not
exist.
Firmware Updating The SiriusConnect™ tuner's firmware is
being updated.
HOME MEDIA GALLERY
Symptoms
Cannot access the network.
Playback does not start while
'Connecting...' continues to
be displayed.
The PC or Internet radio is not
properly operated.
The audio files stored on
components on the network,
such as a PC, cannot be
played back.
(SC-37 only)
Causes
The LAN cable is not firmly connected.
The router is not switched on.
Internet security software is currently installed in
the connected component.
The audio component on the network which has
been switched off is switched on.
The component is currently disconnected from
this receiver or the power supply.
The corresponding IP address is not properly set. Switch on the built-in DHCP server function of
The IP address is being automatically configured. The automatic configuration process takes time.
Windows Media Player 11 or Windows Media
Player 12 is not currently installed on your PC.
Audio files were recorded in formats other than
MP3, WAV (LPCM only), MPEG-4 AAC, FLAC, and
WMA.
Audio files recorded in MPEG-4 AAC or FLAC are
being played back on Windows Media Player 11 or
Windows Media Player 12.
The component connected to the network is not
properly operated.
The component connected to the network does
not permit file sharing.
The folder stored on the component connected to
the network has been deleted or damaged.
Action
Check that the 8 pin mini DIN cable and AC Adapter are
attached securely.
Check for antenna obstructions and reposition the
SIRIUS antenna to get better signal reception. Use the
Antenna Aiming option to optimize the antenna position.
Wait until the channel subscription has been updated.
Wait until the channel information has been updated.
Select another channel.
Wait for updating to finish.
Remedies
Firmly connect the LAN cable (page 38).
Switch on the router.
There are cases where a component with Internet
security software installed cannot be accessed.
Switch on the audio component on the network
before switching on this receiver.
Check whether the component is properly
connected to this receiver or the power supply.
your router, or set up the network manually
according to your network environment
(page 117).
Please wait.
Install Windows Media Player 11 or Windows
Media Player 12 on your PC (page 64).
Play back audio files recorded in MP3, WAV
(LPCM only), MPEG-4 AAC, FLAC, or WMA. Note
that some audio files recorded in these formats
may not be played back on this receiver.
Audio files recorded in MPEG-4 AAC or FLAC
cannot be played back on Windows Media Player
11 or Windows Media Player 12. Try using another
server. Refer to the operation manual supplied
with your server.
Check whether the component is affected by
special circumstances or is in the sleep mode.
Try rebooting the component if necessary.
Try changing the settings for the component
connected to the network.
Check the folder stored on the component
connected to the network.
13
133
En