SpectraLink IP-DECT Server 400 Setup Manual page 15

Spectralink IP-DECT Server Setup Guide—DCP Mode
Warning: Configuration Template provisioning process
Do not log in to the IP-DECT Server 400 (DCP Mode) GUI once this sequence has
started – this action could cause the process to stop unexpectedly.
Do not power off or disconnect the IP-DECT Server 400 (DCP Mode) once this
sequence has started – doing so will stop the process.
Do not remove the IP-DECT Server 400 (DCP Mode) from AMIE once this sequence
has started – doing so will stop the process.
Do not make any changes to the IP-DECT Server 400 (DCP Mode) from AMIE until you
receive a "Configuration Template successfully loaded" notification from AMIE –
doing so could stop the provisioning process.
Within 5-10 minutes, the IP-DECT Server 400 DCP Mode should connect to AMIE. To
ensure that the connection has been successfully established, please verify the following
three items:
1) The server status should show Connected.
2) The Notification Bell should show a new notification.
3) The Server Model should list the server as IP-DECT Server 400 DCP Mode.
Lastly, validate that the Configuration Template has been successfully loaded. This step
finalizes the setup of the IP-DECT Server 400 DCP Mode.
722-0250-000 Rev: A
May 2024 15