NAC Image Technology MEMRECAM GO-12 User Manual page 30

Until the power is turned on
<Check the battery plate before connecting it to the
camera.>
Do not connect the power cable to the camera's power input while the LED on
the battery plate is lit.
Use battery only.
(1) Install the battery plate. Connect the plate's power cable to the camera.
(2) Install the battery.
(3) Press the camera's power button
(1)
Insert the cable all the way until the lock
engages.
(3)
Make sure that POWER LED chang-
es from lit in orange to flash in
blue.
The power LED lights in white when
startup is complete.
Battery plate
Connecting
LED
status
Not lit Not connected
Yellow Connecting
Red Connecting
(2)
The LED on the battery plate lights up.
Battery
Remaining
-
Can be used
Pay attention to the
remaining amount
30
Powering the Battery
Camera replacement
None
Battery Cannot replace
Battery Cannot replace
-
(00512)