formlabs Fuse Blast Manual page 26

5. With two people, carefully roll the machine up the ramp onto the pallet. Take care as the
Fuse Blast may become unbalanced and tip over.
6. Rotate the wheel nuts counterclockwise to lower the rubber feet and lock the caster wheels
into position so the machine does not move.
7. Open the blast chamber door. Unhook the tumbler basket from its mounted position inside
the Fuse Blast. Place the tumbler basket inside the blast chamber so that it lies flat on the
work surface.
8. Move the blast arm into the idle position.
9. Insert the internal foam core support inside the blast chamber. Close and latch the blast
chamber shut.
10. Place the three protective foam supports on the machine.
11. Place the accessories in the accessory box. Place the accessory box at the bottom of the
pallet, next to the bottom foam support.
12. Encase the front and the back of the machine with the two C-fold segments.
13. Place the topper on top of the C-fold segments.
14. Insert the eight plastic clips to the C-fold segments and close the box.
15. Wrap a nylon binding strap (commercially available) horizontally around the C-folds. Position
the strap approximately 50 cm (20 in) up from the bottom of the C-fold. Tighten and crimp
the strap.
16. Loop two nylon binding straps vertically around the machine, passing them underneath
the pallet. Position the two straps approximately 25 cm (10 in) from the left and right sides
of the machine, respectively. Tighten and crimp the straps.
26