Setting Up Your Printer
Configuring network settings
You can connect your ESP All-in-One printer to a wired (Ethernet) network or to a wireless
(WiFi) network. You may refer to the "Start Here" booklet that came with your printer, or
review the following sections as needed.
Configuring an Ethernet network connection
You will need the following items to connect the All–in–One printer printer to a wired
(Ethernet) network:
•
A functional Ethernet network that includes a router, switch, or hub with an Ethernet
port.
•
A CAT-5 (or higher) Ethernet cable
Ethernet setup
1
Plug one end of the Ethernet cable into the Ethernet port located on the back of the All–
in–One printer and the other end into an available port on your Ethernet router or hub.
2
Turn on the printer, if necessary.
3
From the control panel, press
4
Press
5
If you see the setting:
wireless (WiFi) network connections.
6
Use the
assistance.
Configuring a wireless network connection
You can connect your printer to a 802.11 wireless (WiFi) network from the All-in-One
printer control panel.
26
Menu
Network Settings
until
Turn WiFi Radio Off
Manual IP Address
to change the IP Address. See your network provider for
.
is selected, and then press
OK
, press
now. This disconnects any existing
Kodak ESP 9 Printer User Guide
OK
.