Printing - Kodak EASYSHARE-ONE-6 MP User Manual

Troubleshooting

Printing

Problem
Printing does not start NOTE: The EasyShare-One camera is not PictBridge compatible. As such, a USB
Printing stops or is not
complete
Camera prints to the
wrong Wi-Fi enabled
printer
87
Possible causes and/or solutions
connection to Kodak EasyShare printer docks and photo printers is not
supported. However, you can dock the camera on an EasyShare printer dock
(see page 97), or print remotely to a Wi-Fi enabled EasyShare printer.
■
The printer power is off.
■
The printer is busy printing or is engaged in another session, or
has a full buffer.
■
The printer is in an error state. Correct the error.
■
The IP address setting on the camera or printer is incorrect.
Change the IP address or set to Dynamic IP.
■
If printing directly to a Wi-Fi enabled EasyShare printer, check to
make sure the printer, camera, and computer (if using one)
network settings match.
Check for other problems with the wireless network (see
page 82).
■
The printer was disconnected from the camera, computer, or
network in mid-print.
■
The selected printer has the same name as the intended one, and
is on the same network. Change the name of one of the printers
using the printer configuration utility. See the printer user's guide
for details
www.kodak.com/go/support