Table of Contents
Advertisement
Using your camera with a Wi-Fi wireless network
Connecting to a Wi-Fi wireless network
(For definitions of common wireless terms, see
Once connected to a Wi-Fi wireless network, you can use the wireless capabilities of
your camera.
NOTE: The range of a typical Wi-Fi wireless network can vary between 100 to 300 ft (30 to 90 m),
depending on signal obstructions or other interference. Make sure you are in the vicinity of the Wi-Fi
wireless network you want to connect to.
1 Slide the Capture/View switch to View
2 Insert a Kodak Wi-Fi
page
44).
3 Deploy the Wi-Fi card (see
Wireless icon,
The wireless network status light (next to the Wi-Fi card slot) blinks amber as the
camera scans for available networks.
■
If one or more wireless networks are available, the camera checks for a
matching network name, or SSID, from the profiles stored in the camera (see
page
47):
– If a matching SSID is found, and if the Connect Mode of the profile is set to
Auto, the camera attempts to connect to the network.
– If a matching SSID is found, and if the Connect Mode of the profile is set to
Prompt, you must accept the connection before the camera attempts to
connect to the network.
45
®
card (may be sold separately) into the camera (see
page
44). If the card is already deployed, touch the
, located on the bottom toolbar to rescan for available networks.
page
52.)
.
www.kodak.com/go/support
Advertisement
Table of Contents
