Page 1
FF-MIC3 FRENCH FITNESS MIC3 MAGNETIC COMMERCIAL INDOOR CYCLE OWNERS & ASSEMBLY MANUAL...
Page 2
FE AT U RE S • 4KG flywheel • Commercial use • Belt Driven • Magnetic resistance system • Heavy-duty flywheel • Non-slip, multi-position handlebar • Pull resistant way for emergency brake • Anti-perspiration cover prevents sweat from dropping on cast wheel, to extend operating life.
Page 3
T ABL E OF CONT E NT S EXPLODED VIEW ................4 USER MANUAL ................8 INSTALLATION STEPS ..............9 SAFETY INSTRUCTIONS ............... 13...
I NST AL L AT I ON ST E PS Installation steps: 1. Use M10*60 hexagon head bolts (48) and M10 large washers (33 ), respectively, to install and fix the rear foot set (2) and the front foot set (3) to the mounting holes on the main frame (1). 2.
Page 10
Verification of completion assembly (1) All assembly parts are connected normally, and all adjustment hand are tightened without looseness. Handle assembly and cushion assembly fixed firmly without alive shaking. foot is fixed without looseness. Note: tighten the screws and nuts before use to prevent loosening.
Page 11
Adjustment of position handle and seat Before exercise, adjust the handlebars and The position seat. Loosen when turning adjusting handle anticlockwise Open the parts fix the zero when turning the adjusting handle clockwise Pieces. seat handle can be adjusted direction shown Figure 2,3.
Page 12
Training precautions train in the right way, example, When ridinga bicycle, release the handlebars with both hands same time and Stand train. shown in Figure to stop training The inertia wheel of this spinning bike has a large mass. Do not get off the bike directly while the crank is still rotating.
SAFE T Y I NST RU CT I ONS Warning: this manna! contains important safety information. Please read safety instructions carefully before using device. ♦ training equipment is only suitable field of organizing training. such as sports associations, educational institutions, hotels, clubs and gyms.
Need help?
Do you have a question about the MIC3 and is the answer not in the manual?
Questions and answers