Icom IC-M410BB Instruction Manual page 63

D Dealing with ID and Priority
When controllers are connected to the transceiver, the unique ID is automatically
assigned to each controller in order from 1 to 99.
Once a controller is set as the Priority Controller, however, its ID is replaced with 0
because the ID of the Priority Controller ID is fixed at 0.
To check the current ID of each controller, open the "ID" screen.
[MENU] > Settings > Configuration > Controller > ID
L The IDs are for display only and cannot be edited.
L "MIC3" and "External" can be selected for only the
IC-M510BB.
L The ID of an external device is assigned by the
device itself, not by the transceiver.
NOTE: With Non-Priority Controllers, you cannot make changes to the DSC-related
settings listed below. To configure the settings, use the Priority Controller.
Hierarchy
MENU > Settings > Configuration > Inactivity Timer >
MENU > Settings > DSC > Auto ACK >
MENU > Settings > DSC >
When a controller gets disconnected while holding a DSC task:
Controllers are considered disconnected when the following conditions are met.
Controller
Command microphone Unplugged or turned off
External device
Once a controller is disconnected, the right to handle a DSC task will be released.
After that, the first Non-Priority Controller operated will have the right.
L When the Priority Controller is disconnected, the controller names are displayed with
"(None)" appended.
[MENU] > Settings > Configuration > Controller > Priority
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com
DIGITAL SELECTIVE CALLING (DSC)
Condition
The transceiver has not received a single sentence via
the NMEA 0183 interface in the last 2 minutes.
Item
Not DSC Related
DSC Related
Distress Related
RT Related
Individual ACK
Position ACK
Polling ACK
Test ACK
CH Auto Switch
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
50