Icom IC-M410BB Instruction Manual page 51

D Receiving a Position Request call
(May not be used, depending on the presetting)
NOTE: Even if the Auto ACK function is set to "Manual" while waiting to receiving a
distress acknowledgment or after receiving a distress acknowledgment, the Position
Reply is automatically sent to the calling station.
When a Position Request call is received:
• An alarm sounds.
• "RCVD POS REQUEST" is displayed.
1. Push
2. Push the Software Key below the intended
operation.
Ignores the call and returns to
:
the operating screen.
• The call is saved in the DSC Log.
• "
you display the call message.
Holds the RX call task, and
:
returns to the Main screen.
Sends Acknowledgment "Able to
:
comply" right away.
( Able to
comply)
Sends an Acknowledgment
:
"Unable to Comply."
(Unable to
• The call is saved in the DSC Log.
Comply)
• Displays the Acknowledgment
information, and then returns
to the operating screen by
pushing
Accepts the call.
:
• Displays the received call's
information.
• The call is saved in the DSC Log.
Push
push
Reply call.
(p. 30)
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com
DIGITAL SELECTIVE CALLING (DSC)
to turn OFF the alarm.
" blinks continuously until
, and then
or , then
to send the Position
.
7
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
38