Checking 0101 (Read) And 0102 (Write) Commands End Codes - Omron E5ZE-8 Communications Manual

End Codes
DeviceNet Error Codes
Error code
08FF Service not supported
16FF Object does not exist
16FF Device state conflict
0CFF Object state conflict
5-1-3

Checking 0101 (Read) and 0102 (Write) Commands End Codes

Read
Note This data is valid only when using an
OMRON PC Master. If using a master
not manufactured by OMRON, refer to
the manual for that master.
Write
Note This data is valid only when using an
Error code: 0204
Meaning
Processing
Error code: 0401
Meaning
Processing
Meaning
Invalid service code or
instance ID
Invalid class ID
A processing error has
occurred in the Tempera-
ture Controller.
A new command was
received while processing
the previous command.
The responses to commands 0101 and 0102 are described below. The com-
mands have ended normally when the response code is 0000.
No. of bytes
received
OMRON PC Master. If using a master
not manufactured by OMRON, refer to
the manual for that master.
Name: Busy error
A processing error has occurred in the E5ZE.
Turn ON the power to E5ZE again. If the E5ZE is set to continuous communi-
cations and messages are being transmitted, increase the interval between
transmissions.
Name: Undefined command
A command that is not supported by the Unit has been used.
Check the contents of the command data.
Source
MAC ID
Source
No. of bytes
MAC ID
received
Remedy
Check the service code and instance ID set-
tings.
Check the class ID settings.
Resend the DeviceNet explicit message.
Wait for a response to the command being
processed, and then send a new command.
End code Read data
End code
Section 5-1
35