Devicenet Explicit Messages Set Values And Measurement Values - Omron E5ZE-8 Communications Manual

DeviceNet Explicit Messages Set Values and Measurement
4-3-3 Control Data for Sending DeviceNet Explicit Messages Using
CMND(194/490) or IOWR(223)
Master Unit
Unit No. 2
Explicit message
4-4 DeviceNet Explicit Messages Set Values and Measurement
Values
4-4-1 Commonly Used Set Values
Variable Type: 90
No. Address Set value or measurement value
1 0000 Control point 0 process value
2 0001 Control point 1 process value
3 0002 Control point 2 process value
4 0003 Control point 3 process value
5 0004 Control point 4 process value
6 0005 Control point 5 process value
7 0006 Control point 6 process value
8 0007 Control point 7 process value
9 000C Alarm 1 status
10 000D Alarm 2 status
11 000E Auto–tuning status
12 000F HB alarm status
13 0010 HS alarm status
PC
Destination node address
This section provides tables that can be used when setting and monitoring the
set values for all control points. The tables are given by variable type.
IOWR(223) control data
Destination Unit address FE or 12
Destination
node address
(12 indicates Special I/O Unit No. 2)
CMND(194/490) control data
No. of command data bytes
No. of response data types
Data setting or monitoring range
Range: Depends on sensor type used.
(See note 4.)
Unit:Depends on setting (either 0.1 C/ F or
1 C/ F)
Range: 0000 to 80FF
Range: 0000 to 80FF
Range: 0000 to 80FF
Range: 0000 to 80FF
Range: 0000 to 80FF
Section 4-4
Send to local network
Destination Unit address FE or 12
(12 indicates Special I/O Unit No. 2)
Resend once
Data type
Numeric
Read only
Status
Read only
Bit contents same
as remote I/O
contents.
21