Parameters And Menus - Omron E5EK User Manual

1.3 Parameters and Menus

J Parameter types
F Protect mode
F Manual mode
F Level 0 mode
F Level 1 mode
F Level 2 mode
F Setup mode
F Expansion mode
F Option mode
E5EK parameters are distributed between the following nine modes.
Protect mode
Manual mode
Level 0 mode
Level 1 mode
Level 2 mode
Setup mode
Expansion mode
Option mode
Calibration mode
The settings of parameters in each of seven modes (excluding the pro-
tect mode and manual mode) can be checked and modified by selection
on the menu display.
This mode is used to limit use of the menu and
function is for preventing unwanted modification of parameters and
switching between the auto and manual operation.
In this mode, the controller can be switched manual operation. The
manipulated variable can be manipulated manually only in this mode.
Set the controller to this mode during normal operation. In this mode,
you may change the set point during operation, and stop and start op-
eration. You can also monitor (not change) the process value, ramp SP
and manipulated variable.
This is the main mode for adjusting control. In this mode, you can
execute AT (auto-tuning), and set alarm values, the control period and
PID parameters.
This is the auxiliary mode for adjusting control. In this mode, you can
set the parameters for limiting the manipulated variable, switch
between the remote and local modes, switch between the SP modes, and
set the loop break alarm (LBA), alarm hysteresis and the digital filter
value of inputs.
This is the mode for setting the basic specifications. In this mode, you
can set parameters that must be checked or set before operation such as
the input type, scaling, output assignments and direct/reverse opera-
tion.
This is the mode for setting expanded functions. In this mode, you can
set ST (self-tuning), SP setting limiter, selection of advanced PID or
ON/OFF control, specification of the standby sequence resetting
method, time for automatic return to the monitoring display.
This is the mode for setting option functions. You can select this mode
only when the option unit is set in the controller. In this mode, you can
1.3 Parameters and Menus
keys. The protect
A/M
1--7