Level 2 Mode - Omron E5AK PROGRAMMABLE TYPE User Manual

CHAPTER 5 PARAMETERS

Level 2 Mode

• The parameters in this mode can be used only when the "security" parameter
(protect mode) is set to "0" to "2".
• This mode contains the auxiliary parameters for adjusting control. These parame-
ters include parameters for limiting the manipulated variable, parameters for
switching between remote and local operation, and parameters for setting the
LBA (Loop Break Alarm), alarm hysteresis, and input digital filter values.
• To select this mode, press the
to the menu display. If you select [
press the
• To select parameters in this mode, press the
tings, use the
• The following table shows the parameters supported in this mode and the page
where the parameter is described.
5--24
key for 1 second minimum, the controller enters the level 2 mode.
or keys.
Symbol
Remote/Local
Standby time
LBA detection time
MV at reset
MV at PV error
MV upper limit
MV lower limit
MV change rate limit
Input digital filter
Open/close hysteresis
Alarm 1 hysteresis
Alarm 2 hysteresis
Alarm 3 hysteresis
Input shift upper limit
Input shift lower limit
key for 1 second minimum. The display changes
] pressing the
key. To change parameter set-
Parameter Name
and keys, and then
Page
5-25
5-25
5-26
5-26
5-27
5-27
5-27
5-27
5-28
5-28
5-29
5-29
5-29
5-29
5-29