Input Terminals And I/O Terminals - Omron DEVICENET SAFETY - 03-2008 Operation Manual

Functions
Function
Other Functions
Configuration lock
Reset
Password
1-3-2

Input Terminals and I/O Terminals

Function
Maintenance
Network power supply volt-
age monitor
Unit conduction time moni-
tor
Unit name
I/O comments
Last maintenance date
I/O power status monitor
Contact operation
counters
Total ON time monitor
Operation time monitor
After configuration data has been downloaded and verified, the configura-
tion data that has been saved internally can be locked.
DST1-series Terminals can be reset using a service from the Network
Configurator.
A password can be set to prevent the DST1-series Terminal from being
accessed unintentionally.
Note Except for the DST1-MRD08SL-1.
The following functions are provided by the DST1-ID12SL-1, DST1-MD16SL-
1, and DST1-MRD08SL-1.
The present, bottom, and peak values for the network power supply volt-
age can be recorded in the DST1-series Terminal.
The total ON time (unit: 0.1 h) of the internal circuit power can be calcu-
lated and recorded in the DST1-series Terminal.
The user can record a name or comment for each DST1-series Terminal,
using up to 32 characters.
The user can record a name or comment for each I/O terminal, using up to
32 characters.
The date on which maintenance was last performed can be written in the
DST1-series Terminal.
Can be used to check whether the I/O power is ON.
Can be used to count the number of times each input or output contact
changes from OFF to ON (maximum resolution of 50 Hz) and to record the
total in the DST1-series Terminal.
Can be used to calculate the total ON time for each input or output contact
(unit: s) and to record the total in the DST1-series Terminal.
Can be used to measure the time from when an output contact turns OFF
until an input contact turns OFF (unit: ms) and to record the time in the
DST1-series Terminal.
Description
Description
Section 1-3
Reference
Section 3 in
DeviceNet
Safety Sys-
tem Configu-
ration Manual
(Z905)
Reference
Section 7 in
DeviceNet
Safety Sys-
tem Configu-
ration Manual
(Z905)
7