Safety Input Logic Parameter Groups (Safety Input Logic) - Omron DEVICENET SAFETY - 03-2008 Operation Manual

Editing Device Parameters
3-1-7

Safety Input Logic Parameter Groups (Safety Input Logic)

Parameter name
S Input Condition
S Reset Condition
--- Safety Input Logic Com-
ment
Note
Safety input parameter groups can be set only for the DST1-XD0808SL-1. Set
these parameters using the Safety Logic Wizard.
Value
Not Used
Logic operations for
other safety input termi-
nals and remote I/O sig-
nals
Auto Reset
IN6 L-H-L
IN6 Rising Edge
IN7 L-H-L
IN7 Rising Edge
NW L-H-L
NW Rising Edge
48 single-byte characters
max.
Safety input parameter groups can be set only for DST1-XD0808SL-1 safety
inputs IN0 to IN5. For details on DST1-XD0808SL-1 logic functions, refer to 1-
5 Logic Functions.
Description
Does not perform logic operations with safety
input terminals.
Performs logic operations with safety input termi-
nals. The values for the OR operation are set
from AND or OR operations of signals received
from other safety input terminals and remote I/O
(from the Master).
Sets reset conditions and reset input terminals.
The reset conditions are selected from Auto
Reset, L-H-L (Low - High - Low), and Rising
Edge. Values used for reset inputs are selected
from signals received from IN6, IN7, and remote
I/O (from the Master).
Sets the I/O comment for the results of safety
input logic operations (input condition operations
and reset operations). The I/O comment set here
is used as the I/O tag by the NE1A-series Logic
Editor.
Section 3-1
Default
Not Used
Auto Reset
None
35