Uploading And Verifying Device Parameters; Resetting The Device; Uploading The Network Configuration - Omron 3G8F5-DRM21-E - V2 Operation Manual

Uploading and Verifying Device Parameters

5-2-3

Resetting the Device

Device - Reset
1, 2, 3...
5-3

Uploading and Verifying Device Parameters

5-3-1

Uploading the Network Configuration

Network - Upload
1, 2, 3...
To enable the new settings, use the following procedure to reset the network
device.
1. Place the Configurator online.
2. Select the device in the Network Configuration Window.
3. Select Device and Reset.
The following confirmation window will be displayed.
4. Click the Yes Button.
The progress window will be displayed and the devices will be reset.
The new settings will be valid after the devices have been reset.
Note When the devices are reset, communications errors will temporarily occur. For
this reason, do not reset the devices while the master-side PLC (CPU Unit) is
operating
Uploading device parameters refers to writing the parameters from the actual
network devices to the virtual network in the Configurator. Verifying device
parameters refers to comparing the parameters in the actual network devices
with those in the Configurator.
This section explains how to do both of these operations.
Note When the network configuration is uploaded, the parameters for each device
will all be read.
To read the actual network configuration, use the following procedure.
1. Place the Configurator online.
2. Select Network and Upload.
The uploading of the network configuration will start and the following
progress window will be displayed.
The uploading can be canceled by clicking the Abort Button.
Section 5-3
113