Setting Slave Parameters; Editing Slave Parameters - Omron 3G8F5-DRM21-E - V2 Operation Manual

Setting Slave Parameters

4-2

Setting Slave Parameters

4-2-1

Editing Slave Parameters

Device - Parameter - Edit
64
• The following example shows a network device with node address #00
is dragged and dropped on node address #02.
Right mouse button
Drag
• The following example shows a network device with node address #01
is dragged and dropped on node address #02.
Moving direction of existing devices
The parameters of some slaves can be set. However, doing so may cause the
I/O size to change. Because of this, the slave parameters must all be set
before setting the master's parameters.
EDS files are required for setting the parameters. If there are no EDS files
available, they must be obtained from the device manufacturer.
Drop
Moving direction of existing devices
Right mouse button
Drop
Drag
Section 4-2