Setting Node Addresses And Baud Rates Through The Network - Omron 3G8F5-DRM21-E - V2 Operation Manual

Using General-purpose Tools to Set Devices
6-4-2

Setting Node Addresses and Baud Rates through the Network

Tools - Setup Node Address/Baud Rate
1, 2, 3...
136
c) Input Data Area for the Attribute of the parameter to be read.
d) Click the Send Button. The value that was read will be displayed in the
Result area.
2. Parameter setting example
a) Check the Generic option in Service, then select Set Attribute Single
from the drop-down list.
b) Designate the class and instance of the parameter to be set.
c) Input Data Area for the Attribute of the parameter to be set.
d) Input the attribute followed by the value to be set for the parameter in
the Data area.
e) Click the Send Button.
To set the node address and baud rate for the device through the network,
use the following procedure.
1. Set the DeviceNet network so that only the objective device and the Con-
figurator are in operation on the network. Refer to the operation manual of
the device for the factory-set node address and baud rate of the device.
Connect the Configurator to the network at the same baud date.
2. Place the Configurator online.
3. Select Tools and Setup Node Address/Baud Rate.
The following window will be displayed.
4. Set the Target Node Address to the present node address of the objective
device.
5. To change the node address, set the New Node Address to the new node
address and click the Change Button.
The node address will be changed.
Section 6-4