12 2. Trouble Eshooting - Integra Integralift 230 Service Manual

Marked in blue is the Troubleshooting steps that may be done by the user when he or she
calls the service partner and communicates with a duly trained and certified service person.
Integralift does not work
1. Pull out and re-insert the emergency stop plug:
a. Does it beep 3 or 5 times when pulled out and twice at re-insertion? If yes:
i. Check connections in the following order:
ii. Test with new remote control
iii. Test with new interface card
iv. If Integralift is still not working, contact Integra or your local supplier
b. If no (Does not beep):
i. Check connections in the following order:
ii. Test with new connector cable
iii. If Control board does not blink green:
2. If Integralift is still not working, contact Integra or your local supplier.
Integralift lifts up, but will not move downwards.
1. Gently pull the lift strap while driving the lifter downwards.
2. Check the remote control being correctly attached.
3. Pull out and re-insert the emergency stop plug (see also: problem "Integralift does
not work", above)
4. Control that the miniswitches (registering belt tightener and end stop) is correctly
connected to the interface card.
5. If Integralift is still not working; contact Integra or your local retailer.
Integralift 230 – Servicemanual rev2.6
12. Troubleshooting:
1. Is the emergency lowering functioning?
2. Check if the remote control is connected correctly
3. Motor switch activated (green side visible)?
1. Is the charger supplied with power? (green, yellow or red
light?)
2. Motor switch activated?
3. Connector cable connected with interface card?
4. All cables connected with controller card?
1. Control board: 10 A red fuse broken? Replace the fuse.
This will be an effect of overload or control board error.
2. Control board: 5 A brown fuse broken? Replace the fuse.
Wrongful polarization on charger or control board error.
3. Still no green blinking?
a. Replace control board.
13