Work Sharp KEN ONION EDITION KNIFE & TOOL SHARPENER MK.2 User Manual page 30

2. BELT INFORMATION
BELT NAME
Extra-Coarse
Coarse
Medium
Fine
Ultra-Fine
Abrasive belt dimensions: 1" x 18"
Replacement belts and more grit selection available at: www.worksharptools.com
• Engineered abrasives are long lasting and should meet your sharpening needs.
• Keep belts clean and dry for best performance and life.
• Belt grits are labeled on backing (µ=micron)
For reference, belts are equivalent to:
Notice: Only use abrasives recommended for this tool in accordance with these
instructions.
ABRASIVE BELT WEAR:
belts expose new abrasive as they break down. Used belts may take extra
strokes, but will continue to remove material. These belts will keep going longer
than you think. Keep using them as long as they are still removing material
3. BELT CHANGE
Push the Tensioner Lever towards the Tracking Knob and rotate it down to lock
in place.
Remove the current belt from the sharpener.
6 | G E T T I N G T O K N O W Y O U R B L A D E G R I N D I N G A T TA C H M E N T
GRIT COLOR
P120 RED
X65 DARK GREY
X22 LIGHT GREY
X4 WHITE
MEDIUM
12000
GREY
Belt discoloration is not an indicator of wear. Engineered
APPLICATION
Extra-Coarse grit belt for tool sharpening and
knife repair.
Coarse grit belt for knife shaping.
Medium grit belt for knife sharpening.
Fine grit belt for honing knives and scissors.
Ultra-Fine grit belt for serrations, polishing,
and stropping.
(P220) |
X65 X22
(P1000) | (P3000)
X4
.