Work Sharp KEN ONION EDITION KNIFE & TOOL SHARPENER MK.2 User Manual page 13

Notice: Only use abrasives recommended for this tool in accordance with these
instructions.
ABRASIVE BELT WEAR:
belts expose new abrasive as they break down. Used belts may take extra
strokes, but will continue to remove material. These belts will keep going
longer than you think. Keep using them as long as they are still removing material.
5. EDGE GUIDE
WHEN AND WHY TO USE THE EDGE GUIDE:
• Most pocket / outdoor knives are best sharpened without
using the Edge-Guide since they often have thumb studs
or belt clips that can obstruct full blade insertion.
• It is helpful to support and guide long blades (filet
knives and machetes) through the sharpening process.
6. BELT CHANGE
Unplug sharpener from power supply.
Pull up the Belt Change Lever to lock it into place to remove belt.
Route belt around all 3 pulleys. Be sure belt is within pulley flanges.
Press RED Belt Tensioner Release Button to retension the belt.
Lay tool onto its back for easier belt changes.
* Rotate the Edge Guide out of the way for easier belt installation.
PULL UP ON BELT
CHANGE LEVER
Belt discoloration is not an indicator of wear. Engineered
ROTATE SCREW
TO TRACK BELT
BELT TRACKING:
pulley to center the belt on the top pulley.
1 3
Rotate screw above the top
| G E T T I N G T O K N O W Y O U R K E N O N I O N S H A R P E N E R
PULL AND ROTATE