Creality HALOT-ONE User Manual page 14

9. Load Resin 装料
Pour the UV photosensitive resin into the resin vat. The slot capacity is 140ml/170ml/225ml/285ml.
将3D打印机UV光敏树脂倒入料盘，槽位容量分别：140ml/170ml/225ml/285ml。
Tips: How to change resin:
Take out the resin vat slowly, pour out the remaining resin into the container,
clean the resin vat, pour in new resin,and then install the resin vat to the
machine.
提示：如何更换耗材？
将料盘缓缓取出，把剩余树脂倒入容器，清洗干净料盘，重新倒入新树脂，再把料
盘安装到机器即可。
09
Tips: Resin may cause skin irritation or an allergic skin reaction.
please wear gloves before use to avoid direct contact with the
skin.