Appendix 7 Added And Changed Functions - Mitsubishi Electric MELSEC iQ-R Series User Manual

Appendix 7
This section shows the added and changed functions of a C intelligent function module.
Added/changed contents
Data sampling in each sequence scan is supported.
The data analysis function is supported.
Data analysis or statistical analysis using a CPU module
The firmware update function is supported.
Dedicated instructions for data analysis are supported.
Module FBs are supported.
The SD memory card boot function is supported.
A redundant system is supported.
*1 It is available for an RD55UP06-V with a serial number of which the first two digits are '08' or higher.
*2 Use GX Works3 with version '1.105K' or later.
*3 For an RD55UP06-V with a serial number of which the first two digits are '11' or lower or an RD55UP12-V with a serial number of which
the first two digits are '04' or lower, the self-diagnostic function cannot be used in a redundant system even after updating the modules to
firmware version that supports a redundant system by using the firmware update function. (Page 109 Functions)
APPX
114

Appendix 7 Added and Changed Functions

Added and Changed Functions
*2*3
Firmware version
RD55UP06-V RD55UP12-V
"03" "01"
"05"
"07"
*1
"08"
"12" "05"
Reference
Page 39 Sampling Function
Page 21 Data analysis function
Page 22 Data analysis or statistical
analysis using a CPU module
MELSEC iQ-R Module
Configuration Manual
MELSEC iQ-R Programming
Manual (Module Dedicated Instructions)
MELSEC iQ-R C Intelligent Function
Module Function Block Reference
Page 46 SD Memory Card Boot
Function
Page 108 Use in a Redundant
System