Camera Introduction; Set Up The Camera - Reolink Go Ultra Quick Start Manual

Camera Introduction

Status LED
Infrared Lights
Built-In Mic
Lens
Bult-in PIR Sensor
Daylight Sensor
Speaker
USB-C Port
Micro SD Card Slot
SIM Card Slot
Reset Hole
* Press the Reset button with a Pin to restore factory settings.
Battery Status LED
3

Set up the Camera

Activated the SIM Card for the Camera
• Choose a Nano SIM card that supports WCDMA and FDD LTE.
• Activate the card on your smartphone or with your network carrier before inserting it
into the camera.
NOTE:
• Some SIM cards have a PIN code, please use your smartphone to disable the PIN first.
• Do not insert the IoT or M2M SIM into your smartphone.
Register on Network
1. Remove the back cover by rotating counterclockwise and take the battery out of the camera.
2. Peel off the insulation film on the battery.
3. Insert the SIM card into the slot.
4. Insert the battery into the camera and tighten the back cover to power on the camera.
4