Wiring Of Control Circuit; Wiring Method - Mitsubishi Electric 800 Series Instruction Manual

3.3

Wiring of control circuit

3.3.1

Wiring method

(1) Refer to page 31 and treat the wires.
(2) Loosen the terminal screw and insert the cable into the terminal.
(3) Tighten the screw according to the specified tightening torque.
Undertightening may cause cable disconnection or malfunction. Overtightening may cause a short circuit or
malfunction due to damage to the screw or unit.
Tightening torque: 0.5 N•m to 0.6 N•m (terminals A, B, and C)
0.22 N•m to 0.25 N•m (terminals other than described above)
Small flat-blade screwdriver (Tip thickness: 0.4 mm / tip width: 2.5 mm)
3
29
WIRING