Before First Use - TEFAL CB6001 - 04-07 Manual

Thank you for buying this TEFAL appliance, which is intended for domestic use only. Read the
instructions in this leaflet carefully and keep them safe.
The appliance is suitable for outdoor use.
For your safety, this product conforms to all applicable standards and regulations (Low Voltage Directive,
Electromagnetic Compatibility, Food Compliant Materials, Environment, ...).
TEFAL has an ongoing policy of research and development and may modify these products without prior
notice.
Prevention of accidents at home
• Accessible surface
temperatures can be high
when the appliance is
operating.
• Never touch the hot
surfaces of the appliance.
• Never leave the appliance
unattended when plugged
in or in use.

Before first use

Plugging in and preheating
Never place the appliance
directly on a fragile support
(glass table, tablecloth,
varnished furniture, etc.).
To avoid overheating of the
appliance, never place it in a
corner or against a wall.
The supply cord should be
regularly examined for signs
of damage and the
appliance is not to be used if
the cord is damaged.
If the power supply cord is
damaged, it must be
replaced by the
manufacturer or its service
agent or a similarly qualified
person in order to avoid a
hazard.
WARNING: do not use
charcoal or any other
combustible material in the
appliance.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by an adult
responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
• If an accident occurs, rinse the burn immediately with cold water
and call a doctor if necessary.
Remove all packaging, stickers or miscellaneous accessories inside
and outside the appliance.
Clean the protective cover (1b) or the windshield (1a) (according to
the model), the grill plate (2) and the drip tray (3): follow the
instructions in the "After use" paragraph.
Place the appliance on its support legs or on a flat, stable, heat-
resistant surface.
Avoid using it on a soft base.
Unwind the cord completely.
Check that the electrical installation is compatible with the
power and voltage indicated on the bottom of the appliance.
Only plug the appliance into earthed sockets.
Supply the appliance through a residual current device (RCD)
having a tripping current not exceeding 30 mA.
If an extension cord is used:
- this must be earthed and rated accordingly;
- take all precautions necessary to ensure that no one will get
tangled in it.
The heating element terminals of the appliance must always
be dried thoroughly before using the appliance.
• If your model has a windshield (1a), put it in place (A1), (B1),
(C1).
• If your model has a protective cover (1b), open it (D2).
Clip the locking strut (6) of the cover (1b) into place (E2).
Insert the control unit (4) fully into the appliance (D1) (D2) and then
plug into the mains: the pilot lamp lights up.
The control unit (4) cannot be inserted when the cover is
closed.
Do not use any other control unit (4) other than the one
supplied with your appliance.
• Never plug in the appliance when the protective cover (1b)
is closed.
F
NL
D
I
S
FIN
DK
N
GB
TR
E
P
GR
RUS
UA
45