Table of Contents
Advertisement
Welch Allyn VDX-300 Illumination and Imaging System
Fuse Replacement
1.
Turn the Power Switch OFF and remove the Power Cord from the Platform
Box.
2.
Remove the Fuse Drawer by pinching the two side tabs and firmly pulling
out. Remove the fuses by carefully pulling out of the fuse drawer.
3.
Check the fuse condition. If a fuse is blown, replace with Welch Allyn part
number VA303 or equivalent fuse (2.0 Amp, 250 Volt, 5 x 20 mm, Fast Bio).
Be sure to check both fuses.
NOTE:
If the Platform Box blows the new fuse, contact Welch Allyn's Product
Service Group.
Page 14
WelchAUyn
Advertisement
Table of Contents
