D Selecting The Receive Band; Setting A Frequency; D Selecting The 1 Mhz Tuning; D Selecting A Tuning Step - Icom IC-R15 Basic Manual

3
BASIC OPERATION
■ Receiving

D Selecting the receive band

1. Push [V/MHz] to select the VFO mode.
2. Push [QUICK].
3. Select "Select Band."
4. Select the receive band.
• Sets the receive band, then returns to the Standby
screen.
L In the VFO mode, you can also change the band by
pushing D-pad().

■ Setting a frequency

You can select an operating frequency by rotating [DIAL].
L When receiving a signal, the S-meter displays the received
signal strength.

D Selecting the 1 MHz tuning

You can change the operating frequency in 1 MHz steps
for quick tuning.
1. In the VFO mode, push [V/MHz].
• Enters the 1 MHz Tuning Select mode, and the 1 MHz
digit blinks.
2. Rotate [DIAL].
• The frequency changes in 1 MHz steps.
3. Push [V/MHz].
• Exits the 1 MHz Tuning Select mode.
L The tuning step setting (above) remains.

D Selecting a tuning step

When you select the frequency by rotating [DIAL] in the
VFO mode, it changes in the selected tuning step.
1. Push [QUICK].
2. Select "TS."
3. Select a tuning step.
Options (kHz):
5.0 6.25
25.0 30.0
*
For only VHF AIR band (108.000 MHz ~ 136.991 MHz).
• Sets the tuning step, then returns to the Standby screen.
L You can set the tuning step for both the VFO and
Memory mode.
L The VFO mode scan and the Band Scope function
16
also use this step to search for signals.
8.33* 10.0 12.5
50.0 100.0 125.0
15.0 20.0
200.0
Blinks
The 1 MHz Tuning
Select mode