Set Number Of Measurements - Wavetek IS-136 MS Operating Instructions Manual

IS-136 MS

Set Number of Measurements

To set the number of measurements in the AUTORUN or remote-control mode,
use the following IEEE command only if the screen shows the IS-136 basic mask,
the constellation display or the numeric display:
SPECIR[value]
10-56
[value] = Number of measurements (any figure be-
tween 01 and FF is permissible,
eg SPECIR0A for 10 measurements).
After loading the system program or after a reset the default
value is 1.
Set Number of Measurements