Wavetek IS-136 MS Operating Instructions Manual page 22

IS-136 MS
A
+
D
MTXOFFset* ERR Frequency error of mobile transmitter in current analog TC.
A
MPOWER* PWR Mobile output power in current analog TC (see appendix).
RESULt6* ERR Frequency error of mobile transmitter in current digital TC.
D
RESULt7* PWR Mobile output power in current digital TC (see appendix).
* Querying with these IEEE commands is only possible in single-step mode after each
step. In auto-handoff mode IEEE querying by evaluation of PRINT data.
Scroll fields
Select type of target channel
Cross to test on up to five random chan-
nels
Cross to test on sequence of channels
Cross if test results to be printed out
Cross to continuously repeat test (end
with )
{STOP}
10-22
Select the other test conditions shown in Fig. 10.11.
Press
{SINGLE_STEP}
: the test is stopped when the result of the
{SINGLE_STEP}
current channel is available. Pressing the softkey will
move you to the next predefined channel and display the
test results.
: the test runs through to the end without
{AUTO-HANDOFF}
interrupting for each channel.
{RETURN} takes you back to the basic test mask.
Test Results
Mobile could change to predefined TCs: AUTO HANDOFF
mask shows current channel number plus values measured for
frequency error and transmitting power of mobile in current
channel (ERR and PWR).
Mobile could not change to predefined TCs: connection
breaks off (softkey
{STOP}
If measurement exceeds limits in any channel.
If measurement exceeds limits in any channel.
Fig. 10.11: AUTO-HANDOFF mask. To get
measurement results for the output power
PWR the mobile has to work at a power level
> +17 dBm.
Handoff Procedures
or to start the test.
{AUTO-HANDOFF}
changes to
{RETURN}
Entry fields
before end of test).
Results