Test Callup - Wavetek IS-136 MS Operating Instructions Manual

IS-136 MS

Test Callup

More than five tests can be called up from the basic IS-136 test mask, so the
softkeys have three levels with different functions assigned to them. Use
reach the required level:
-ETC- EXECUTE
-ETC-
-ETC-
The basic IS-136 mask shows all test results in the righthand half of the screen
(Fig. 10.7). The entry sectors (analog/digital) are assigned the appropriate
display sectors. Depending on what type of traffic channel the connection was
directed to (analog/digital), only the corresponding display sector will show test
results. The other sector remains blank.

To set the number of measurements in the AUTORUN or remote-control mode,
use the IEEE command described in the appendix.
10-12
RELEASE
AUTO SP-LOOP
BER MAHO
MOBILE CELL.
HOOKFLSH REGISTER
CONST. MOD-SPEC
Fig. 10.7: Basic IS-136 test mask after call
setup in analog TC
Analog sector
Digital sector
Test Callup
to
{ETC}
RETURN
RETURN
BURSTS