Handoff Procedures; Change Analog/Digital Traffic Channel - Wavetek IS-136 MS Operating Instructions Manual

IS-136 MS

Handoff Procedures

You use the handoff procedures to test whether the mobile – during a call –
correctly adopts changes in transmission parameters (channel, SAT, power level,
time slot, etc) as instructed by the base station (ie the test setup).

Do not forget to confirm every change in an entry field of the basic mask with
.
[ENTER]

Change analog/digital traffic channel

WHY?
Requirement
10-20
Test whether the mobile correctly changes to another
analog/digital TC. All variants are permissible, eg also
changing from an analog to a digital TC and from
800 MHz DTC to 1900 MHz DTC (and vice versa).
Test whether the frequency error and transmitting power
of the mobile in the target channel meets requirements.
The mobile is not in test mode.
Make the general test preparations.
Initiate a call with
{MOBILE}
in an analog or digital traffic channel).
Handoff Procedures
or (the mobile must be
{CELL.}