Inverter Parameter Introduction - GE GEP4.6-1C-10 User Manual

System Commissioning

8.2.2 Inverter Parameter Introduction

Parameters
Normal
E-Today
E-Total
Vpv
Ipv
Iac
Fac
Error History
GEP5.0-1C-10
Ver
Set Language
Set Time
RSSI
W/L Reset
W/L Reload
PF Adjust
Shadow MPPT
Power Limit
Set Power Limit
Set Modbus Addr
Description
Home page. Indicates the real-time power of the inverter. Long press for
2s to check the current safety code.
Check the generated power of the system for that day.
Check the total generated power of the system.
Check the DC input voltage of the inverter.
Check the DC input current of the inverter.
Check the AC output current of the inverter.
Check the frequency of the utility grid.
Check historical error message records of the inverter.
Indicates the specific inverter model. Long press for 2s to set the safety
code. Set the safety country in compliance with the local grid standards
and application scenario of the inverter.
Check the software version.
Set language accordingly.
Set time according to the actual time in the country/region where the
inverter is located.
Indicates the received signal strength of the GPRS module and 4G
module.
Power off and restart the WiFi module.
Restore the factory settings of the WiFi module. Reconfigure the WiFi
module network parameters after restoring the factory settings.
Set the power factor of the inverter according to actual situation.
Enable the shadow scan function if the PV panels are shadowed.
Soft limit: Set the power feed into the utility grid according to local
requirements and standards.
Hard limit: The inverter and the utility grid will automatically disconnect
when the power feeds into the grid excesses the required limit.
Set the power feed back into the utility grid according to the actual
situation.
Set the actual Modbus address.
User Manual V1.1-2022-08-01
32