Inverter Parameter Introduction - GE GEP3.5-1-10 User Manual

System Commissioning

8.2.2 Inverter Parameter Introduction

Parameters
Vac
Iac
Fac
VPv1/2
IPv1/2
VERSION
SERIA NO:
Language
Date&Time
Modbud Address
W/L Reset
W/L Reload
Country Code
Grid Connection
Error Log
Power Limit
PF Value
Shadow
LVRT
HVRT
Grid Type
Password
Description
Check the voltage of the utility grid.
Check the AC output current of the inverter.
Check the frequency of the utility grid.
Check the DC input voltage of the inverter.
Check the DC input current of the inverter.
Check the ARM software version.
Check the serial number of the inverter.
Set language accordingly.
Set time according to the actual time in the country/region where the
inverter is located.
Set the actual Modbus address.
Power off and restart the communication module.
Restore the factory settings of the communication module.
Reconfigure the communication module network parameters after
restoring the factory settings,
Set the safety country/region in compliance with the local grid
standards and application scenario of the inverter.
Set to connect or disconnect the grid.
Check historical error message records of the inverter.
Set the power feed back into the utility grid according to the actual
situation.
Set the power factor of the inverter according to the actual situation.
Enable the shadow scan function if the PV panels are shadowed.
With LVRT on, the inverter will stay connected with the utility grid
after a short-term utility grid low voltage exception occurs.
With HVRT on, the inverter will stay connected with the utility grid
after a short-term utility grid high voltage exception occurs.
Set the grid type according to the actual grid type. Supported grid
type: star grid and delta grid.
The password can be changed. Keep the changed password in mind
after changing it. Contact the after-sales service if you forget the
password.
User Manual V1.0-2022-05-05
36