Table of Contents
Advertisement
C L E A N I N G T H E E X T R A C T O R
Careful maintenance ensures the correct operation and optimal performance.
C AU T I O N :
The downdraft must be disconnected from the electrical network, both by unplugging the
appliance from the socket and activating the magnetic circuit breaker (safety cut-out), before
removing the metal grease filters. After cleaning operations, replace the metal grease filters as
outlined in the installation instructions.
M A I N T E N A N C E
H O W TO P R O C E E D ?
Cleaning external
Do not use metallic scrubbers, abrasive
surfaces and
products, or hard brushes.
accessories
Grease filters
After 30 hours of operation, the
downdraft will signal the grease filter
saturation.
Saturation is indicated by the flashing
RED colour LED speed indicator, when
the cooker hood is off.
To reset, hold down the
for at least 3 seconds, while the carriage
is open.
Active charcoal filter
In the recirculation mode, the active
charcoal filter must be replaced
A -
I M E R
periodically.
Press to activate a 10 minute timer, after which the motor is turned off and the top panel
is closed. The setting of this function is signaled by the flashing of the speed indicators.
To remove the charcoal filter see
'CHARCOAL FILTER MAINTENANCE'
B - D E C R E A S E S P E E D
Press to decrease the speed of the motor.
L I Q U I D I N S I D E P R O D U C T
If there is liquid inside the product, it is possible to remove it by removing the caps located under
C - I N C R E A S E S P E E D
Press to increase the speed of the motor.
the hood housing (FIg.13).
D - M O T O R S P E E D I N D I C A T O R S
The 4 LEDs emit a red light, depending on the set speed.
First speed: 1 LED On
Second speed: 2 LEDs On
Third speed: 3 LEDs On
Fourth speed: 4 LEDs On
E - P O W E R
When the product is switched off, the first touch opens starts to open the top panel. Once it is
fully open to 90° the second speed of extraction is automatically set. Pressing the button further
will stop the motor and close the top panel.
20
Instruction manual DD523BK
A
B
C
D
E
L I Q U I D I N S I D E P R O D U C T
If there is liquid inside the product, it is possible to remove it by removing the cap
hood housing (FIg.13).
F F i i g g . . 13
Please keep this instruction manual for future reference
A C C E S S O RY P R O D U C T S TO U S E
To clean the external surfaces of the downdraft
and the light housing screen use only
commercially available household detergents
diluted in water. Then rinse with clean water and
dry with a soft cloth.
The grease filters can be washed by hand or in
the dishwasher. These filters need to be cleaned
on a regular basis, because otherwise they may
represent a fire risk.
Refit the grease filters and front panel, making
sure that they are properly fitted at the sides
so that it does not cause the downdraft to stop
timer button
operating.
HOW THE
DOWNDRAFT WORKS
Push button control panel (fig. 8)
A: 10 minutes timer, after which the motor is
turned off and the front is closed.
The setting of the function is signaled by
indicator(B) flashing.
B: The motor speed indicator.
The LED gives off four different colors, depending
on the set speed.
First speed color: WHITE
Second speed color: GREEN
Third speed color: BLUE
Fourth speed color: RED
C: The key is only active with open top (45° 90°).
For each selection of the function there is an
increase of the motor speed, up to the fourth
speed.
D: the key is only active with open top (45° 90°).
Each time you select the function you have a
speed decrease of the motor, up to the first
speed.
E: When the product is switched off, the first
touch activates the top panel until it reaches the
intermediate opening of 45°.
As the intermediate opening is reached, the
motor is automatically set to the 2nd speed.
Another press will start full opening (90°) of
the top panel, maintaining the speed of the motor.
Another press will stop the motor and completely
close the top panel.
NOTE:
- When the top panel is opened at 45°, hold down
the E button for 3 seconds, the top panel will
close and the motor turns off.
- When the top panel is closed, hold down the E
button for 3 seconds, the top panels opens by 90°
and the motor is activated at the second speed.
Warning: The product DD522BK allows the
opening of the glass top only by 90° (no 45°
opening is possible).
TIMING
As a res
EU66 " E
pean Co
January
ted to co
All of the
requirem
including
when the
Internal m
higher th
vice that
from 4th
External
motors th
de a time
speed w
Motors In
Remote
650m³/h
following
The suct
4th to 2n
If the app
matically
operation
during op
The ener
– by mod
Other fu
Automati
After 4 h
setup, th
Grease fi
After 30
"B" will
grease fi
the "TIM
while the
Fig
Advertisement
Table of Contents
